I recently came across a problem with a Buffalo LinkStation Live. When I plugged the NAS into my computer, and ran the Buffalo NAS Navigator, it reported that the drive was in 'EM Mode'. After several hours of fiddling around, I eventually managed to get it up and running again. The only way to do this is to either upgrade or flash the firmware. Don't worry, the process is safe and shouldn't damage any of your data. Here's how I did it (you must have a Windows PC to hand to perform the operation): • Make sure that there are no other devices on your network which may interfere with the LinkStation, such as a firewall, or another NAS Drive. • Directly connect the drive to an ethernet port on the network.

Figure 3: LinkStation Duo board. The Kirkwood is also used in the LinkStation Pro LS-XHL, which was a chart-topper for single drive NASes not too long ago. But where the LS-XHL uses a 1.2 GHz Kirkwood, Buffalo opted for a less expensive 600 MHz version for the Duo, which unfortunately results in significantly lower performance. Hi all, just a quick couple of questions.I have a Buffalo LS-WXL704, LINKSTATION DUO set up in Raid 1 (Mirror) with 2x2TB WD Green Drives (wd20EARS-00MVWB0) Installed a few years ago.On reflection.

• This step is crucial for the operation to succeed. Open up Buffalo NAS Navigator, and click 'Refresh'. Once the EM drive appears, right click it, select Properties and change it to an IP Address which is not currently being used. It may ask for a password, leave the box blank, and press enter.

They will even help you pick out the right one for you by using the wizard available on their website. Also, if you want to save money and get everything at once, you have a version that gives you exactly that. You can select the version you need and then customize it with only the right plugins for you. Fl 12 5 skins.

If leaving the box blank does not work, you will need to enter your current password for the drive. • Once the drive is on a Static IP address, you will need to download the latest firmware for the product from. • After this has been downloaded, open up 'LSUpdater.exe'. Select your NAS from the list and start the process. The process takes approximately 10-15 minutes. DO NOT unplug the drive until the upgrade has completed.

If the upgrade failed, try running again. It took me two attempts to get it working on one occasion. Hope this helps. Please note: I accept NO responsibility for any lost data, since it is your own choice if you decide to take the steps above. I am simply providing them as a reference/help to anyone who has the same problem. Adding to Luke’s info, If you get an error that a partition can not be found during the Updater Progress, Then modify the LSUpdater.ini file and change the “NoFormatting” Value to “0” as follows: NoFormatting=0.

Then rerun the LSUpdater.exe. Be sure to change the value back to “1” if you run the LSUpdater.exe again after running it with a value of “0” Thus you don’t want to keep re-formatting the drives every time you run the LSUpdater.exe. Ashley horner becoming extraordinary free pdf. Now that’s not to say that you may need to re-format again. This process is a trial and error. But for the most part try to limit formatting to just once.